2000 Ford Ranger No clutch pedal pressure

2000 FORD RANGER
Avatar
JOHN.PULLEY
  • MEMBER
  • 1 POST
Transmission problem
2000 Ford Ranger 4 cyl Two Wheel Drive Manual 78K miles

Added DOT3 fluid to level and clutch worked fine. The following day lost clutch pressure, there is no visible leak.
Feb 26, 2009 at 9:29 PM
Advertisement
Avatar
DAVE H
  • ✓Experienced Mechanic
  • 13,384 POSTS
Hello .. thanks for the donation .. much appreciated

Was the the reservoir empty or real low when you topped it up ! is it empty again now ! it is possible air has gotten into the sytem and needs bleeding off ? if the fluid reservoir is low or empty again now .. you must have a leak somewhere ? or it was real low and has now gotten air trapped ? let me know

The hydraulic clutch control system consists of the hydraulic master cylinder, slave cylinder, reservoir, clutch pedal position switch and connecting hydraulic lines. The clutch disc and pressure plate are single-disc type. The clutch release bearing or bearing arm is activated by hydraulic pressure. The clutch linkage or pedal position requires no adjustments.
Feb 26, 2009 at 10:49 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.