2000 Ford Ranger crankshaft position sensor

2000 FORD RANGER
160,000 MILES • 4 CYL • 2WD • AUTOMATIC
Avatar
TOBISUKLINE
  • MEMBER
  • 1 POST
were is the crankshaft position sensor located on a 2000 ford ranger 2.5 liter and when it goes bad does it throw the timing off, and when installing the part does it have to be re timed somehow.
Dec 31, 2007 at 10:02 PM
Advertisement
Avatar
BMRFIXIT
  • ✓ASE Certified Mechanic
  • 19,053 POSTS
  • ASE Certified Mechanic
[quote:40660fb677="tobisukline"]Other Category problem
2000 Ford Ranger 4 cyl Two Wheel Drive Automatic 160000 miles
----------------------------------------------------------------
were is the crankshaft position sensor located on a 2000 ford ranger 2.5 liter and when it goes bad does it throw the timing off, and when installing the part does it have to be re timed somehow.[/quote:40660fb677]


crank shaft pulley
when it goes bad car wont start
no need for any adj after u replace it
Dec 31, 2007 at 10:07 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.