2000 Ford Ranger abs

2000 FORD RANGER
79,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
DONNIE FLETCHER
  • MEMBER
  • 1 POST
took fuse out of my abs to disable them. regular brakes work fine. if abs is enabled a lot of weird things happen when the truck has almost come to a stop. the brakes seem to be working until the truck is almost stopped and then they release and the truck glides for a yard or two.
Nov 15, 2008 at 10:41 AM
Advertisement
Avatar
DAVE H
  • ✓ASE Certified Mechanic
  • 13,384 POSTS
  • ASE Certified Mechanic
LOSS OF SENSOR SIGNAL DURING VEHICLE DECELERATION OR SENSOR SIGNAL DROPS OUT AT LOW SPEED
Possible source of problem may be: faulty ABS sensor indicator, weak sensor output, or faulty air gap. Check front and rear ABS sensor indicators. Check ABS sensor mounting for debris or corrosion. See TEST D: ABS SENSOR OUTPUT FAILURE - DTCS C1233, C1234 & C1237 under DIAGNOSTIC TESTS
Nov 15, 2008 at 10:53 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.