1998 Ford Ranger Clutch Master and slave cylinder

1998 FORD RANGER
101,434 MILES • 6 CYL • 2WD • MANUAL
Avatar
CHRISBOB12
  • MEMBER
  • 1 POST
Please tell me the proper way to remove and replace the clutch master and slave cylinder. How to remove the spring loaded switch on the clutch push rod. How to disconnect the slave cylinder line to the master cylinder.
Thank you very much.
Bob,
Jun 22, 2010 at 5:30 PM
Advertisement
Avatar
BLUELIGHTNIN6
  • ✓ASE Certified Mechanic
  • 16,542 POSTS
  • ASE Certified Mechanic


https://images.2carpros.com/forum/automotive_pictures/261618_Noname_2346.jpg


https://images.2carpros.com/forum/automotive_pictures/261618_Noname2_768.jpg


https://images.2carpros.com/forum/automotive_pictures/261618_Noname3_285.jpg


https://images.2carpros.com/forum/automotive_pictures/261618_Noname4_134.jpg


https://images.2carpros.com/forum/automotive_pictures/261618_Noname5_58.jpg

Jun 22, 2010 at 6:03 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.