1994 Ford Ranger Removal and repair of front starboard side

1994 FORD RANGER
275,000 MILES • 6 CYL • 4WD • MANUAL
Avatar
JP47
  • MEMBER
  • 1 POST
How do I get the drive shaft out of the transfer case. It seems to have a snap ring or something holding it in. I was told to take a large screwdriver or prybar and give it a good wack? LOL Thanks
Nov 4, 2009 at 6:36 AM
Advertisement
Avatar
BLUELIGHTNIN6
  • ✓Experienced Mechanic
  • 16,542 POSTS
Push the flanged end of the axle shafts toward the center of the vehicle and remove the C-lockwasher from the end of the axle shaft.
Nov 4, 2009 at 7:27 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.