1988 Ford Ranger Hudraulic clutch system

1988 FORD RANGER
Avatar
JMMENDEZ
  • MEMBER
  • 1 POST
Transmission problem
1988 Ford Ranger 6 cyl Two Wheel Drive 81000 miles

How do I disconnect the hydraulic line and where is the best place when pulling the engine and transmission together
Feb 9, 2009 at 6:17 AM
Avatar
GERALD L
  • MEMBER
  • 2 POSTS
bleeding the clutch hydraulics can be a major pain so I reccomend disconnecting clutch petal and removing master cylinder and fluid reservoir and pull them with the engine and tranny. But you can disconnect hydraulics by punching out small pin on master cylinder and pulling hose off.
Feb 11, 2009 at 12:58 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle