2006 Ford Mustang Blower Switch only works on high

2006 FORD MUSTANG
29,000 MILES • 6 CYL • 2WD • MANUAL
Avatar
HERMUSTANG
  • MEMBER
  • 1 POST
Turned on the blower switch and smelled wire insulation smoking. Now blower switch only works on high speed setting. Relay or switch? Owner service-able? Known issue or campaign? Out of warranty.
Jul 22, 2009 at 3:48 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
Inspect and test the blower motor resistor this is the one that controls the speed of the blower motor by using resistors. Replace it -Its located behind right side of dash-sorry no pic for exact location
Jul 22, 2009 at 4:34 PM
Advertisement