1964 Ford Galaxie

1964 FORD GALAXIE
Avatar
MANUEL RAMOS
  • MEMBER
  • 1 POST
Engine Performance problem
1964 Ford Galaxie V8

Hi, I bought a new gas sending unit and gas gauge it still read 1/2 tank I have no gas in it I rewire the wire still the same reading but when t take the unit out and raise the float up reads full and push down reads empty but when I insert the unit back in goes back to 1/2 there's no gas in the tank
Jun 30, 2010 at 9:23 PM
Advertisement
Avatar
RICHZOMBIE
  • ASE Certified Mechanic
  • 173 POSTS
  • ASE Certified Mechanic
Sometime you can buy faulty items new. Remove the wire from the fuel level sending unit and ground it. If the gauge goes to full then the gauge is fine and the sending unit is bad. Do this with the key in the on position so that the gauges have power going to them. If the sending unit checks out fine then it could be a gauge problem or even a dash voltage regulator problem.
Jun 30, 2010 at 10:06 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.