I need directions and pictures on replacing the EGR hose/pipe....Thanks
May 24, 2010 at 2:49 PM
EGR hose/pipe replacement
2003 FORD FOCUS
SYLVIA2555
- MEMBER
- 8 POSTS
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
Hello,
It’s a very straightforward job: disconnect the two rubber hoses that go to the DPFE sensor (make a note of which one goes to which port on the tube), unbolt the tube at the exhaust manifold (2 bolts) and at the EGR (may be pretty tight, and rusty; use some liquid wrench if needed). When installing the new EGR tube, make sure to install a new EGR tube gasket at the manifold ($2), and reconnect the two hoses.
It’s a very straightforward job: disconnect the two rubber hoses that go to the DPFE sensor (make a note of which one goes to which port on the tube), unbolt the tube at the exhaust manifold (2 bolts) and at the EGR (may be pretty tight, and rusty; use some liquid wrench if needed). When installing the new EGR tube, make sure to install a new EGR tube gasket at the manifold ($2), and reconnect the two hoses.
May 26, 2010 at 11:52 AM
Advertisement