1990 Ford F150

158,000 MILES • V8 • 2WD • AUTOMATIC
Avatar
GERMANMECH
  • MEMBER
  • 1 POST
I just put a motor in my f150. I change water pump and a thermostat before i put it back in th vehicle, after i starter this used engine it stated ok , but after a feww minutes it starts to shake, and it shut off, I notice that water is not circulating thru the radiator, could thid be causin the engine to shut off. and waht can I do next?
Feb 3, 2009 at 8:24 AM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,246 POSTS
Did it over heat? Could the radiator be plugged? Are you sure the coolant is full throughout the engine? As far as the no start, coolant not circulating won't cause the engine not to start, but over heating it can cause problems.

Let me know.

Joe
Feb 4, 2009 at 8:42 AM
Avatar
GERMANMECH
  • MEMBER
  • 1 POST
I took the thermostat out and ran the vehicle w/out it and the water pump seem to be worj\king ok, what i notice was that the water was like brownish like color, like rusted out, I change water but it steel coming out rusted like, the car runs for few minutes but it shuts off if i press the acelerator and take acelarator out it shuts off. it is my first time changin a motor on a ford van everything is wekll conected but it does chakes and goes to normal and then shakes again few times and the shuts off.
Feb 4, 2009 at 1:31 PM
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,246 POSTS
It sounds like the cooling system needs flushed again. The brown is rust that is in the block. As far as the engine. Are you sure the timing is right and the vacuum advance is working?

Joe
Feb 5, 2009 at 2:36 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle