Hello
The information I am giving you applies to a V6, 4.0L Vin E since you did not specify. There is also a 4.0L Vin K flex fuel and a 4.6L Vin W.
Hope this helps.
IGNITION SWITCH LOCK CYLINDER - NON-FUNCTIONAL
Removal and Installation
Disconnect the battery ground cable and wait at least one minute.
Remove the screws and the instrument panel steering column cover.
CAUTION: Do not use a prying device to detach the shift lever boot or damage to the shrouds may result. Detach the boot from the shrouds.
Remove the screws and the steering column lower shroud.
Disconnect the electrical connector.
Remove the screw and the PATS transceiver.
CAUTION: Do not allow the drill bit to make contact with the column housing or damage to the housing will result. If there is damage to the housing a new column must be installed. Use a 3/16-inch diameter drill bit to drill out the lock cylinder retaining pin and remove the ignition switch lock cylinder.
Discard the lock cylinder. Remove the drill shavings from the steering column.
To install, reverse the removal procedure.
Verify the ignition switch lock cylinder operation.
Oct 27, 2008 at 1:03 PM
