1994 Ford Explorer clutch slave cylinder

1994 FORD EXPLORER
156,000 MILES • 6 CYL • 4WD • MANUAL
Avatar
ROLL
  • MEMBER
  • 1 POST
i was just wondering if you could tell me the easiest way to remove the line from the clutch slave cylinderi dont have the tool but i was told i could use a thin screwdriver to pop the line out.
thanks
Jan 3, 2008 at 6:34 AM
Advertisement
Avatar
ARTMANG
  • MEMBER
  • 61 POSTS
just use a thin nail screw driver or just something hard and thin to be able to push out the small cilinder clip.i use a thin nail and gently tap it with a hammer till it comes out half way then ill just pull the rest out with pliers.
Jan 4, 2008 at 4:26 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.