1993 Ford E-Series Van will not start, no spark

1993 FORD E-SERIES VAN
Avatar
HOWIE
  • MEMBER
  • 3 POSTS
Electrical problem
1993 Ford E-Series Van V8 Two Wheel Drive Automatic

I have no 12v to coil, wiring diagram shows fuse in line and says it is engine compartment fuse panel
i n a certain location 30 amp desiginated "U". There is no fuse where the diagram shows. There is a relay
there. This diagram says it is for this van but it appears the fuse is somewhere else. It is the 302 v8
can you tell me where it is ?
Nov 28, 2008 at 3:30 PM
Advertisement
Avatar
RASMATAZ
  • ASE Certified Mechanic
  • 75,992 POSTS
  • ASE Certified Mechanic
Check fuse no. 7
Nov 28, 2008 at 3:36 PM
Avatar
HOWIE
  • MEMBER
  • 3 POSTS
How will I be asked to pay a donation ? credit card ? will i be billed ?y
Nov 29, 2008 at 1:35 PM
Avatar
RASMATAZ
  • ASE Certified Mechanic
  • 75,992 POSTS
  • ASE Certified Mechanic
Why you asked-what's wrong?
Nov 29, 2008 at 1:37 PM
Avatar
HOWIE
  • MEMBER
  • 3 POSTS
I am a bit confused . i asked for help and received good information that led me to the location of a fuse i was looking for. As a result I would like to make a $5.00 donation . I was asking how will i pay this ? by credit card? will I be sent a bill or what ?
Thank for the help
Nov 29, 2008 at 2:16 PM
Avatar
RASMATAZ
  • ASE Certified Mechanic
  • 75,992 POSTS
  • ASE Certified Mechanic
I believe its a credit card-I guess if you decide the $5.00 and approve it-it'll go thru-it will show in your statement-Thank You very much and you have a nice day God Bless
Nov 29, 2008 at 2:26 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.