1997 Ford Crown Victoria Mech cannot detect probelm

1997 FORD CROWN VICTORIA
159,000 MILES • V8 • 2WD • AUTOMATIC
Avatar
MRDAVIS
  • MEMBER
  • 1 POST
Have this car presently at shop with 2 master mech with much expericance the story goes like this, car running fine, I changed oil, cleaned the battery cable of rust on neg side only. After starting it up, the engine idiels fine, yet, it dogs out when giving it gas and it will not get any power. The mech and went through and triple check all normal problems yet, come up with no answer. Please advise if possible?
Apr 10, 2008 at 3:24 PM
Advertisement
Avatar
MASTERTECHTIM
  • ✓ASE Certified Mechanic
  • 4,750 POSTS
  • ASE Certified Mechanic
recheck the battery connections and replace terminal ends if you have to. also try unplugging mass air flow sensor and see if that makes it ruyn better, if it does then replace it.
Apr 10, 2008 at 3:27 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.