1996 Ford Contour clutch problems

1996 FORD CONTOUR
200,000 MILES • 4 CYL • FWD • MANUAL
Avatar
DEEZWILLY
  • MEMBER
  • 1 POST
I have replaced clutch master and slave cylinder. I have no tension on pedal (as in it goes to floor; no resistance). There is chance friction plate was not put on facing right direction, if this can be a problem.
May 9, 2008 at 4:29 PM
Advertisement
Avatar
MASTERTECHTIM
  • ✓ASE Certified Mechanic
  • 4,750 POSTS
  • ASE Certified Mechanic
did you try bleeding the hydralics first? can you see the clutch fork move when pressing the pedal down? i dont think you can install the clutch disc backwards as it wont bolt down. id be looking and double checking the hydraulics first. let us know how you make out or if you need further assistance
May 9, 2008 at 6:22 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.