1985 Ford Bronco Truck stopped, now not starting,....fuel p

1985 FORD BRONCO
225,000 MILES • V8 • 4WD • AUTOMATIC
Avatar
BLUESTRAVELER
  • MEMBER
  • 2 POSTS
The truck was driving and just stopped, I replaced the ignition module because it worked before....stab in the dark.
Replaced the high pressure fuel pump, no luck.... I'm not getting any fuel to the cylinders.

Question, does the fuel inertia switch reset once you start cranking the engine,...if so, is it then the in-tank pump? or do you have another suggestion?
Mar 5, 2010 at 10:08 AM
Avatar
MERLIN2021
  • ✓Experienced Mechanic
  • 17,250 POSTS
Inertia switch only trips during a collision. Reseting is not automatic, the red button must be pushed down, Did you check for spark? The ignition switch could be defective, Or the fuel pump relay, or the PCM power relay, those are in the under hood power distribution center.
Mar 6, 2010 at 9:25 AM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle