after fixing fuel pump and replaced camshaft sensor it will not start

2002 NISSAN ALTIMA
120,000 MILES • 2.5L • 4 CYL • 2WD • MANUAL
Avatar
CHELSA-ELIZABETH RADUS
  • MEMBER
  • 1 POST
Car started after initial replacement of pump and camshaft sensor we drove the car parked it, had to remove pump to check floater gauge. We tried to start car again and it would not turn over, and realized we were leaking gas from front of car near engine/dashboard. It only leaks when we are trying to turn over vehicle! Any information would help.
Oct 16, 2017 at 3:00 PM
Avatar
MHPAUTOS
  • ✓Experienced Mechanic
  • 31,937 POSTS
During crank start the starter is on for a few seconds to build up fuel pressure, you will have to trace the fuel lines to see where it is leaking. cycling the key will pull the pump in when the pressure drops, you should not have a problem locating this leak. post back with your findings for further assistance.
Oct 16, 2017 at 5:00 PM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle