Error Code P1153 - Manufacterer Control

2001 CHEVROLET SUBURBAN
204,000 MILES
Avatar
UPMM019
  • MEMBER
  • 217 POSTS
So I bought a 2001 Chevrolet Suburban 1500 4wd LT.

When I got it there were many codes so thus far I have replaced an o2 sensor, plugs, wires, EGR Valve..... the suburban runs great but keeps throwing P1153 Manufacturer Control error code.

Looking for guidance on how to resolve this error code, if possible, DIY solution.

Nov 4, 2013 at 7:17 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
SATURNTECH9
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 30,869 POSTS
Which engine do you have?
Nov 4, 2013 at 7:55 AM
Advertisement
Avatar
UPMM019
  • MEMBER
  • 217 POSTS
Engine Type 5.3L V8 16V OHV
Nov 4, 2013 at 8:00 AM
Avatar
WRENCHTECH
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 20,761 POSTS
Which 0/2 sensor did you replace because the one with the issue now is on the passenger side.
Nov 4, 2013 at 8:46 AM
Avatar
UPMM019
  • MEMBER
  • 217 POSTS
I replaced the o2 sensor on the passenger side before the converter.

Nov 4, 2013 at 8:49 AM
Avatar
WRENCHTECH
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 20,761 POSTS
Did you clear the code after? Can you access the data stream to see what that sensor is doing?
Nov 4, 2013 at 9:02 AM
Avatar
UPMM019
  • MEMBER
  • 217 POSTS
code has been cleared but i don't have anything to access the stream info.

I just have a cheap reader.
Nov 4, 2013 at 9:06 AM
Avatar
UPMM019
  • MEMBER
  • 217 POSTS
After my last post I cleared the code and made it till today and the service engine came back on.... same darn code....

Nov 7, 2013 at 5:23 PM