Engine check and slip indicator light stay on

2011 TOYOTA CAMRY
179,000 MILES • 2.4L • 4 CYL • 2WD • AUTOMATIC
Avatar
JACKY YAN
  • MEMBER
  • 1 POST
My car is listed above petrol. Yesterday when I was driving on high way the slip indicator and engine check yellow light were on. I tried to turned off and restart engine after I arrived my destination later. But the lights are still on. When I turn on the key, the engine check light stay on after dashboard finish self check. Then when I move the car the slip indicator shows again and stay on all the time.
I have disconnected the negative of battery for more than five minutes and check the gas cap but it doesn't work.
I tried to use jump wire to get fault code. The ABS light flashing shows 41 which means abnormal voltage.
What should I do next step?
Plus, all other performance of my car is good.
Thanks,
Jack
Jul 19, 2019 at 2:43 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
Welcome to 2CarPros.

First, I need you to scan the computer using an OBD2 scanner. Here is a video showing how it is done:

https://youtu.be/YV3TRZwer8k

I need to know what codes you get. I'm not familiar with a 41 and couldn't find it on the manufacturer's list.

Next, the slip light is usually related to a faulty wheel speed sensor, but we will wait to see what the codes say. In the meantime, if you want to check wheel speed sensors, here is a link that explains how:

https://www.2carpros.com/articles/abs-wheel-speed-sensor-test

Let me know what you find and what codes are pulled.

Take care,
joe
Jul 20, 2019 at 10:10 PM
Advertisement