Electrical

2005 CHEVROLET SUBURBAN
152,000 MILES • 5.3L • V8 • 4WD • AUTOMATIC
Avatar
JRCDADDY
  • MEMBER
  • 4 POSTS
Hello. I just replaced my stepper motors on my cluster. But now all my back LEDs are out. I checked all the connections and they seem good. Could they possibly be all burned out? Or maybe a fuse?
Jun 29, 2016 at 11:18 PM
Advertisement
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
normally the cluster is pulled out and rebuilt not just a stepper motor. Regardless it has to be reprogrammed to your car.
Jun 30, 2016 at 3:32 AM
Avatar
JRCDADDY
  • MEMBER
  • 4 POSTS
Yes actually all the stepper motors were replaced because they were sticking. It is a common problem with this make. But now it looks like all the back lighting/LEDs are out. Possibly needs to be replaced also.
Jun 30, 2016 at 10:39 PM
Avatar
STRAILER
  • ✓Experienced Mechanic
  • 55,051 POSTS
You might of got an open connection, try removing the cluster again and then leaving the wiring hooked up and wiggle it to see if you can get the connection back. Its would be really rare that all the lights burned out at once.

Best, Ken
Jul 6, 2016 at 1:24 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.