Replaced crank sensor, cam sensor both and battery. Engine turns over but will not start, not even with ether.
Mar 6, 2022 at 5:38 PM
Crank no start issue
2006 FORD FUSION
JOHNNY RUSSELL
- MEMBER
- 1 POST
Advertisement
Good morning,
When you crank the engine, does the tach on the dash show any RPM? If it does, then the crank sensor is sending a signal to the ECM.
https://www.2carpros.com/articles/car-not-running-advanced
You need to check spark and compression to be sure there are no internal motor issues.
https://www.2carpros.com/articles/how-to-test-engine-compression
https://www.2carpros.com/articles/how-to-test-an-ignition-system
Roy
When you crank the engine, does the tach on the dash show any RPM? If it does, then the crank sensor is sending a signal to the ECM.
https://www.2carpros.com/articles/car-not-running-advanced
You need to check spark and compression to be sure there are no internal motor issues.
https://www.2carpros.com/articles/how-to-test-engine-compression
https://www.2carpros.com/articles/how-to-test-an-ignition-system
Roy
Mar 6, 2022 at 6:08 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.