After replacing carrier bearing there is a roaring noise and a vibration

Tiny
JBURTON18
  • MEMBER
  • 2005 CHEVROLET EQUINOX
  • 3.4L
  • V6
  • 4WD
  • AUTOMATIC
  • 183,000 MILES
Removed driveshaft to replace carrier bearing and u-joint put it all back together and when driving it have a roaring noise and a vibration. What could cause this? We heated up slip yoke to get it off to access carrier bearing.
Thursday, February 14th, 2019 AT 3:17 PM

9 Replies

Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
Good evening,

Does the sound come from the driveshaft area?

Were there any complications assembling it? Did you get the slip yoke to move freely with installation?

Roy
Was this
answer
helpful?
Yes
No
Thursday, February 14th, 2019 AT 3:45 PM
Tiny
JBURTON18
  • MEMBER
  • 5 POSTS
Yes, the noise is coming from driveshaft area and the slip yoke I'm referring to doesn't move unless driveshaft does. It's the one at the joint of the driveshafts pieces.
Was this
answer
helpful?
Yes
No
Thursday, February 14th, 2019 AT 4:06 PM
Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
I know where it is at as I have done many of them.

If the joint does not move freely, it will stress the bearing and cause noise.

If you disable the AWD, does it still make noise?

Roy
Was this
answer
helpful?
Yes
No
Thursday, February 14th, 2019 AT 4:09 PM
Tiny
JBURTON18
  • MEMBER
  • 5 POSTS
I removed the driveshaft because I don't know of a way to disable the awd and the noise stops. No when you say move freely what exactly do you mean?
Was this
answer
helpful?
Yes
No
Thursday, February 14th, 2019 AT 4:10 PM
Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
The slip yoke in the center should slide in and out easily.

If it does not make any noise with the shaft out, you could be getting noise from the rear differential.

You can disable it by disconnecting an ABS sensor. When the ABS light comes on the AWD will be disabled.

Roy
Was this
answer
helpful?
Yes
No
Thursday, February 14th, 2019 AT 4:17 PM
Tiny
JBURTON18
  • MEMBER
  • 5 POSTS
My ABS light is on due to a bad sensor. When the driveshaft isn't in it makes noise when it's not it doesn't. The slip yoke doesn't move. Is it supposed to like slide in and out?
Was this
answer
helpful?
Yes
No
Thursday, February 14th, 2019 AT 4:36 PM
Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
Yes it is.

It does sound like you have an issue with the rear differential.

Roy
Was this
answer
helpful?
Yes
No
Thursday, February 14th, 2019 AT 4:39 PM
Tiny
JBURTON18
  • MEMBER
  • 5 POSTS
Okay, thank you.
Was this
answer
helpful?
Yes
No
Thursday, February 14th, 2019 AT 5:04 PM
Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
You are welcome.

Roy
Was this
answer
helpful?
Yes
No
Thursday, February 14th, 2019 AT 5:21 PM

Please login or register to post a reply.

Sponsored links