Drive Side Tail Light

1997 CHEVROLET TRUCK
210,000 MILES • 5.7L • V8 • 4WD • AUTOMATIC
Avatar
HUNTER GLAVIN
  • MEMBER
  • 1 POST
Hello,
So on my K1500 my tail light first did not light up when the brakes where applied. All the other lights worked fine. And after a couple of days after which I replaced the circuit board for the tail light, now all three lights have stopped working and my turn signal acts like a little kid who stutters. Need help please!
Mar 15, 2017 at 7:22 PM
Advertisement
Avatar
HMAC300
  • ✓ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
check the ground at left hand rear of frame it may be corroded or broken off clean it and then see what happens. then if you have had a trailer plug installed check that for connections as a lot of problem appear due to the cheap connectors they use causing broken wires to lights.
Mar 16, 2017 at 7:16 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.