Drive gear does not work

2007 JEEP PATRIOT
125,000 MILES • 2.4L • 4 CYL • 4WD • AUTOMATIC
Avatar
MIK3Y1995
  • MEMBER
  • 1 POST
When I put my vehicle in drive I have no power to the front wheels. I can engage 4x4 and my rear wheels will work and if I put it in low gear everything works fine. what could be the problem?
Feb 18, 2019 at 8:24 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
STEVE W.
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 15,146 POSTS
Welcome to 2CarPros. Your description sounds like the front differential or one of the front axles has failed. That Jeep uses front wheel drive normally. When you select 4X4 it engages the rear axle, 4X4 low is actually the same thing except it sets the CVT into a "lower" gear to simulate a low range in the transfer case. The rear PTU is driven off the same gearing as the front so it is either the differential or an axle issue.
Feb 18, 2019 at 4:35 PM
Advertisement