1996 Dodge Van engine will not start

1996 DODGE VAN
122,000 MILES • V8 • 2WD • AUTOMATIC
Avatar
SKID MARK2
  • MEMBER
  • 1 POST
I just replaced the intake plenum gasket to get rid of a lean left bank code. Now I am getting a P0320 code , how do I test the crank position sensor , and the cam shaft position sensor ( distributor ) . I have fuel pressure and spark , just not at the correct time.
Apr 3, 2010 at 12:47 PM
Advertisement
Avatar
CARADIODOC
  • ✓Experienced Mechanic
  • 34,413 POSTS
If you have spark, the camshaft position sensor and crankshaft position sensor are working. When pulses are recieved from those sensors, the Engine Computer turns on the Automatic Shutdown (ASD) relay which sends power to the injectors, coil, oxygen sensor heaters and fuel pump or pump relay. Is it possible the code was set earlier and not erased?

caradiodoc
Apr 3, 2010 at 6:05 PM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle