1999 Dodge Stratus Timing Belt/Bent Valves

1999 DODGE STRATUS
176,000 MILES • 4 CYL • 2WD • AUTOMATIC
Avatar
ROSIECTC
  • MEMBER
  • 1 POST
My timing belt broke, and my boyfriend was able to replace it, but he said that the valves are bent. He had a hard time removing the bottom gear, and it took many hours rather than two. Are the valves really difficult to replace? And does my car have a noninterference engine?
May 1, 2008 at 2:17 AM
Advertisement
Avatar
BMRFIXIT
  • ✓ASE Certified Mechanic
  • 19,053 POSTS
  • ASE Certified Mechanic
80 % yes
do a compression test
if valve need to be replaced cylinder head need to be removed
its like doing a head gasket job
May 4, 2008 at 5:50 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.