1990 Dodge Colt mikuni fuel injection

1990 DODGE COLT
140,000 MILES • 4 CYL • FWD • MANUAL
Avatar
JAMES BATES
  • MEMBER
  • 1 POST
after driving and car is warmed up engine fails to restart flooded i thinkn will start with gentle push im assuming an engine coolant sensor isnot telling the mikuni injection syetem not to enrich the fuel mixture however i havent been able to find any informtion on the layout or parts i.d. is there a manuel with this information available . or anybody experiencing similar problems thanks for your help

j. bates
Sep 4, 2008 at 5:45 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
DOCFIXIT
  • CAR REPAIR CONTRIBUTOR
  • 18,828 POSTS
Hi j.bates
The coolant temp sensor is located by the thermostat housing and has a two wire connector. Remove connector you will need an ohm meter check resistance between terminals at 100 F should read 1100 ohms at 180 F 300 ohms if not replace.
On this site you can get repair info at Online Car Repair Manual. Let me if I can help further.
Thank you for your donation
Sep 5, 2008 at 9:25 AM
Advertisement