Crankshaft position sensor

2000 GMC YUKON

130,000 MILES • 5.7L • V8

NATEPANK79

MEMBER
1 POST
FOLLOW

My crankshaft position sensor is smaller in diameter than the design one. I was told that the brass cup inside needs to come out. Need instructions on how to do it.

Oct 9, 2019 at 4:47 PM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.

DANNY L

AUTOMOTIVE REPAIR CONTRIBUTOR
5,648 POSTS

Hello, I'm Danny.

Here are the instructions you've requested on removing and replacing the crankshaft position sensor. Here is a tutorial to view for replacement:

https://www.2carpros.com/articles/crankshaft-angle-sensor-replacement

I've attached picture steps below for your crankshaft position sensor replacement on your vehicle. I've also attached a picture below of the correct GM part number for your sensor. Hope this helps and thanks for using 2CarPros.

Images (Click to enlarge)

Dec 7, 2020 at 9:55 PM