clutch replacement torque specs needed?

Sure, here are the torque specs you have requested.

Manual transmission flywheel to crankshaft S62 / M62 / M62TU - Do not install with screw retaining compound. Bolts are a component of the flywheel.

Oil screw threads. 105 Nm

Manual transmission flywheel to crankshaft M44 / M73 / M73TU

Replace screws 120 Nm

All others Replace screws 105 Nm

Automatic transmission flywheel to crankshaft

All Replace screws 120 Nm


-------

Clutch to Flywheel

M8 Bolts [Grade 8.8] 24 Nm
M8 Bolts [Grade 10.9] 34 Nm

----

They don't say what the rear main housing bolts are. Let us know if you need anything else.

S62 / M62 / M62TU I think these are for v8s.

Mone i think is the zf.

This is for the 6 cylinder I rechecked it.

I checked. All of them are for v8s except the m44 which is a 4 cylinder It's on Wikipedia and many other sites. I am very familiar with these numbers too, that's why i asked. The 6-cylinder inline are usually the m54 abd m52.

Sorry, my bad I was looking up the convertible. Here is the inline 6 cylinder:

Manual transmission flywheel to crankshaft S62 / M62 / M62TU - Do not install with screw retaining compound. Bolts are a component of the flywheel. Oil screw threads. 105 Nm

Clutch to Flywheel

M8 Bolts [Grade 8.8] 24 Nm
M8 Bolts [Grade 10.9] 34 Nm

Let us know if you need anything else.

S62, m62 are v8s.

Hmm, Alldata must have it wrong, sorry.

The 2001 BMW 330Ci does not come with the S62 or M62 V8 engines. Instead, it is equipped with the M54 inline-six engine.

Yes, I know, that is why I am hesitant to use these numbers.

I don't blame you, do you know of another car that has this engine? I can try looking that up.

All BMW 3 series 2000-2006, and 525 same years.

This is what they show, check out the images (below).