Clutch problem

2005 MAZDA 6
1,275,000 MILES • 2.0L • 2WD • MANUAL
Avatar
MARTYG85
  • MEMBER
  • 1 POST
Hi, my clutch was sticking to the floor and I had to pull it back out with my foot and it was hard to put it into gear and then it would not go into gear. so I had to stop the car and start it in gear but it would not move . all it is doing is making a rattling noise when idle but when you press the clutch in the noise goes away. what would the problem be?
Dec 10, 2017 at 2:54 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
Chances are the slave cylinder or clutch master cylinder is empty or bad. Follow these directions:

https://www.2carpros.com/articles/clutch-doesnt-work-sometimes-or-not-at-all
Dec 11, 2017 at 5:48 PM
Advertisement