Clutch pedal

2004 HYUNDAI SONATA
142,000 MILES • 2.4L • 4 CYL • 2WD • MANUAL
Avatar
OUTLAWZIMMORTAL
  • MEMBER
  • 1 POST
Changed clutch master cylinder and slave cylinder after the original clutch master cylinder went out pedal goes to floor when the bleeder is open close the bleeder pedal pops up then gets hard to push I do if I don't have it adjusted just right no slipping from transmission at all how can I fix without replacing clutch
Nov 27, 2018 at 5:58 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
STRAILER
  • CAR REPAIR CONTRIBUTOR
  • 54,189 POSTS
Hello,

It sounds like you have a clutch disc that is falling apart holding the pressure plate from fully releasing. Here is a video and guide on a similar car that shows how to remove the transmission and replace the clutch:

https://youtu.be/6N6b5F2ChyE

and

https://www.2carpros.com/articles/how-to-replace-a-clutch

Please run down these guides and report back.

Cheers, Ken
Nov 29, 2018 at 11:49 AM
Advertisement