Clutch not working it went to the floor

Welcome to 2carpros.com

Here are the directions specific to your vehicle for bleeding the system. Try this and let me know if it helps.

____________________

1988 Chevy Truck C 1500 Truck 2WD V8-350 5.7L
System Bleeding
Vehicle Transmission and Drivetrain Clutch Service and Repair Procedures System Bleeding
SYSTEM BLEEDING
Note: When refilling or bleeding system, use on new brake fluid conforming to DOT 3 or DOT 4 specifications.

1. Raise and support vehicle.

2. Remove slave cylinder retaining nuts, then the slave cylinder.

3. While holding Slave cylinder at approximately 45 degrees with bleeder at highest point, have an assistant depress clutch pedal while opening bleeder valve.

4. With clutch pedal held at end of stroke, close bleeder valve and release clutch pedal.

5. Repeat steps 3 and 4 until all air has been expelled from system. While bleeding clutch system, constantly check master cylinder reservoir fluid level and replenish as necessary to prevent master cylinder running out of fluid.

____________________

Let me know if it is helpful.

Take care,
Joe

I’ll try that for sure but my truck everyone says my clutch is inverted meaning I have to raise the clutch pedal up and leave it up when you depress my pedal it stops all flow of the fluid to the master

Welcome back:

I just checked pro-demand (Snap-on) and Alldata manuals and both indicate the same bleeding procedure I indicated. I'm not sure if you have something different, but that's what is indicated. Try it and let me know if it works. If it doesn't we'll figure it out another way.

Take care,
Joe

Okay thanks man I’ll definitely try it

Happy to help. Let me know if it works or not. I will watch for your reply

Take care,
Joe

Is it supposed to take like a few minutes before the clutch comes all the way back up? Jus wondering if that’s normal or if my master cylinder is busted

No, sir. The clutch pedal should return quickly.