2007 Chrysler Town and Country abs light

2007 CHRYSLER TOWN AND COUNTRY
57,000 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
JGALYEN
  • MEMBER
  • 1 POST
abs light is on and i am wondering if there are more than one sensors to get checked out i am going to check fuse first then move on to the rest i have already reset the comp by disconecting hot wire from batt
Mar 6, 2010 at 7:39 AM
Advertisement
Avatar
CARADIODOC
  • ✓ASE Certified Mechanic
  • 34,321 POSTS
  • ASE Certified Mechanic
When the light is on, a diagnostic fault code has been memorized in the ABS computer. Disconnecting the battery will not make the problem fix itself, but it will erase that valuable diagnostic information. Your mechanic will connect a hand-held computer to read the code(s). That will indicate the circuit with the problem, not necessarily the defective part.

There are four wheel speed sensors, a pressure sensor, and a whole bunch of solenoids in the hydraulic controller. All of these are monitored as well as various electrical inputs to the computer.

caradiodoc
Mar 17, 2021 at 7:24 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.