2002 Chrysler Town and Country powersteering

2002 CHRYSLER TOWN AND COUNTRY
98,000 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
DANIEL ROJO
  • MEMBER
  • 1 POST
I've replaaced the pump and pulley.
I bled the system as suggested, But I feel a rasp or a slight vibration as I make a sharp turn. Everything was installed properly.
Apr 4, 2009 at 5:20 AM
Advertisement
Avatar
CARADIODOC
  • ✓Experienced Mechanic
  • 34,381 POSTS
Still has air in the system. Give it time. If it's still doing it a week from now, run each front wheel up on a curb, one at a time, to raise it higher than the other side, then turn the steering wheel from lock to lock. That's part of the bleeding procedure, but rarely is necessary.

You should also check the pressure hose to be sure it's not touching something or pulled tight and transmitting normal noise into the passenger compartment.

caradiodoc
Apr 4, 2009 at 11:22 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.