SPONSORED LINKS

1997 Chrysler Town and Country Battery went out

Tiny
LEEMCLEMORE
  • MEMBER
  • 1997 CHRYSLER TOWN AND COUNTRY
  • 6 CYL
  • 2WD
  • AUTOMATIC
  • 165,000 MILES
The battery was replaced and the ac and rear wiper lights are flashing when the vehicle is started. The ac works and cools. What buttons do I push to reset this? Thanks I have already sent a donation a few minutes ago. Lee
Monday, August 18th, 2008 AT 3:46 PM

1 Reply

Tiny
RLMTEX51
  • MEMBER
  • 2 POSTS
With engine on set blower motor to high, set mode position knob to panel (i.E. Full left), open all A/C outlets, set temperature to cold (both levers if so equipped). Now press the wash and rear wiper buttons on the A/C panel simultaneously for 5 seconds (until all LED's light). This should get the test started. Assorted lights on this panel will flash as different tests are run. Eventually if the tests are passed the rear wiper LED should be the only light flashing. Push the rear wiper button to exit test mode and you should be home free.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, August 19th, 2008 AT 9:54 AM

Please login or register to post a reply.

Related Battery Replace/Remove Content

Battery Replacement
VIDEO
Battery Replacement
Instructional repair video
Battery Replacement
GUIDE
Battery Replacement
Replacing a car battery is easy to do and will take about 20 minutes in most cases, this job can be done using everyday tools. Please wear protective gloves and eyewear when...
VIEW MORE

Sponsored links