1998 Chrysler Sebring Headlamp Replacement

1998 CHRYSLER SEBRING
125,000 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
MILEHI
  • MEMBER
  • 1 POST
I'm trying to figure out how to 'release' the headlamp assembly to change the bulbs. There are no release pins but there appear to two (2) torx scews at the top to each side that hold the assempby in place, but not sure; of course, i do not have the right size torx screwdriver/bit either. But before I but a set of torzxs I would like to make sure that this is the way these are mounted

Can you confirmt hat this is how the assembly is mounted?

Thansk you - Jay
Jan 10, 2009 at 2:16 PM
Advertisement
Avatar
ZACKMAN
  • ✓ASE Certified Mechanic
  • 4,202 POSTS
  • ASE Certified Mechanic
Yes it is. You will need T25 Torx screw driver to remove them. The entire assembly comes out, remove the wiring harness from the back side, remove the headlight trim ring and pull the bulb out. Install is reverse.

NOTE: Don't touch the glass with your hand.
Jan 11, 2009 at 2:02 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.