2001 Other Chrysler Models jeep four wheel drive

2001 CHRYSLER
98,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
MMCGREGOR
  • MEMBER
  • 1 POST
the jeep drives fine in two wheel drive. When you shift properly into four wheel drive and take off it makes a noise and vibrates. what would cause it not to engage or partialy engage if that is what is happening?
Feb 26, 2010 at 12:29 PM
Advertisement
Avatar
CARADIODOC
  • ✓ASE Certified Mechanic
  • 34,321 POSTS
  • ASE Certified Mechanic
Check the universal joints in the driveshaft for looseness or binding. I can't remember if the axle joints are u-joints or cv joints. If there is a worn outer universal joint, I doubt you will feel a vibration at low speeds, but if one is binding, it will force the steering wheel back to center if you turn and start to move.

caradiodoc
Feb 28, 2010 at 2:08 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.