Caliper problem

CHRYSLER NEW YORKER
Avatar
NEON2007
  • MEMBER
  • 1 POST
For a 1994 Chrysler New Yorker, I would like to know how do I put the caliper back on the way it was when I took it off. Because , I just had it replaced and for some reason the break plug that connects to the caliper does not want to go back on. Any advice would help me out. Thank You !
Sep 22, 2007 at 3:24 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
MERLIN2021
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 17,250 POSTS
I think you are asking "how do I connect the hose to the caliper?" If you have a screw in hose the threads must be the same size...if you have the banjo bolt type, you will have 2 copper washers put 1 new washer on the bolt, put bolt thru the hose, put 2nd washer over the bolt, screw bolt into the caliper...hand tighten!
Sep 22, 2007 at 5:01 PM
Advertisement