1999 Chrysler Concorde PASSENGER SIDE MIRROR REPLACEMENT

1999 CHRYSLER CONCORDE
86,750 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
MITCH0350
  • MEMBER
  • 1 POST
I NEED INSTRUCTION FOR REMOVING AND REPLACING THE PASSENGER SIDE MIRROR ON A 1999 CHRYSLER CONCORDE LXI?
Nov 2, 2009 at 8:47 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
CH112063
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 1,320 POSTS
Is this a power mirror? or manual remote with the joystick? The cover inside came off, and you found three 10mm nuts. Deep socket, 1/4 inch drive. The length of the connector, and/or Knob, would tell you if the trim panel had to come off and it usually did not. Sometimes that panel that was black, inside had a hidden screw inside, and it required the door panel removal. If the joystick type was on the mirror, you needed a tiny allen handle, and on the door, the joystick cover screwed off normally counter clockwise. The newer mirrors and the smaller ones used 3 plastic sheet metal screws. Instead of nuts. Sorry I don't have the LH manual but the 2carpros does.
Nov 6, 2009 at 8:49 PM
Advertisement
Avatar
JOEL SMITH
  • MEMBER
  • 1 POST
I have a 99 Chrysler concord lxi it's a power mirror, what do I need to replace it
Aug 18, 2019 at 9:52 AM
Avatar
KASEKENNY
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 18,907 POSTS
This process is going to be the same. If you remove the interior trim piece that is on the inside of the door where the mirror is, you will see 3 nuts. Remove these and the mirror will pull off the outside of the car. Then you will find a connector inside. Disconnect the connector and then install the new mirror.
Aug 18, 2019 at 11:56 AM