1997 chrysler concorde

1997 CHRYSLER CONCORDE
Avatar
JJ72775
  • MEMBER
  • 2 POSTS
I have a 1997 chrysler concorde with 110,000 miles.
Automatic w/ 3.5L motor.
I just had tires replaced.

Prior to and after my tire replacement I experience a bad vibration.

This occurs between 40-60 mph while my foot is on the gas. If I do not have my foot on the gas between these speeds then there is no vibration.
The vibration comes from the front of the car.

Is it the CV joints?

Thank you for your time and help. They are appreciated.
Sincerely
Jaijef
Sep 27, 2007 at 11:38 AM
Advertisement
Avatar
2CARPRO JACK
  • ✓ASE Certified Mechanic
  • 11,533 POSTS
  • ASE Certified Mechanic
Could be, does th efront end make a clunk noise when you saw the wheel back and forth? mCheck the inner tie rod ends, HUGE problem with them.Blow the rubber bushings right out of them
Sep 27, 2007 at 12:50 PM
Avatar
JJ72775
  • MEMBER
  • 2 POSTS
I had the tie rods replaced in May at the dealership. Will check for clunking noise.
thank you again.
sincerely
jaijef
Sep 28, 2007 at 12:01 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.