Chrysler cylinder head

WAYNE_44

MEMBER
CHRYSLER CIRRUS

Do you think I will have to take the engine out of my chrysler cirrus to change the head?

Wednesday, December 6th, 2006 AT 6:05 PM

1 Reply

CANVIS69

MEMBER
131 POSTS

Probably not. Most modern top ends allow the lower end to remain. Because the motor mounts attach to the short block. If it has a little bar to the head it's only a torq strut.

Please login or register to post a reply.

Related Cylinder Head Replace/Remove Content

1996 Chrysler Cirrus Vacuum Hose Problem

I Did The Spark Plugs And Had To Take The Manifold Off When I Did That The Vacuum Hose Disconnected Some Where And I Don't Know Where.I...

Asked by curtusbriggs ·

4 ANSWERS

1 IMAGE

1996

CHRYSLER CIRRUS

VIDEO

Cylinder Head Removal

Instructional repair video

Idle Speed Control Motor Connector

How Do You Know If Your Car Needs A New Idle Air Control Motor?

Asked by kitms7 ·

9 ANSWERS

1998

CHRYSLER CIRRUS

2000 Cirrus Leak Behind Fly Wheel Unknown

Chrysler Cirrus 2000 2.5 Leaks Water Down Out Fly Wheel Plate, No Visual Where It Comes From Everythings Dry. It Jus Pours Out The Plate....

Asked by Tom steal ·

1 ANSWER

2000

CHRYSLER CIRRUS

95 Cirrus Lxi Computer Or Electrical Problem

I Have An Automatic Transmission, 2.5l V6 Engine. A Little After I Purchased The Car The Speedometer Started Freezing While I Was Driving...

Asked by hrysewyk ·

1 ANSWER

1995

CHRYSLER CIRRUS

Tune Up

Cirruis 96 Lxi V-6 Hesitate When Trying To Start Replaced Feul Pump.

Asked by jmartin2k5 ·

1 ANSWER

1996

CHRYSLER CIRRUS

Chrysler cylinder head

1 Reply

Please login or register to post a reply.

Related Cylinder Head Replace/Remove Content

1996 Chrysler Cirrus Vacuum Hose Problem

Idle Speed Control Motor Connector

2000 Cirrus Leak Behind Fly Wheel Unknown

95 Cirrus Lxi Computer Or Electrical Problem

Tune Up

Sponsored links