1990 Chevy Silverado Broken coolant system fitting

98,000 MILES • V8 • 2WD • AUTOMATIC
Avatar
THEDAYS4
  • MEMBER
  • 1 POST
When trying to remove the quick disconnect fitting located at the top rear of the engine (feed hose to heater), the fitting broke off flush with the engine. I've soaked it in liquid wrench and tried to remove it with an "easy out" with no success; it's frozen solid! See picture below.

Any suggestions?

[img]

http://www.2carpros.com/forum/automotive_pictures/153652_Engine_Repair_2.jpg[/img]
Feb 5, 2008 at 2:07 AM
Advertisement
Avatar
MERLIN2021
  • ✓Experienced Mechanic
  • 17,250 POSTS
You will have to drill and tap with a 1/2 inch pipe threader, parts stores sell the kit...BTW I don't see a picture!
Feb 5, 2008 at 2:10 AM
Avatar
MERLIN2021
  • ✓Experienced Mechanic
  • 17,250 POSTS
From: thedays4
To: merlin2021
Posted: Tue Feb 05, 2008 2:00 pm
Subject: 1990 Chevrolet Silverado broken coolent system fitting
Thanks for your reply. Sorry about the lack of picture. I followed the "Add a Picture" instructions but apparently it doesn't work. I tried again here but it just provides a link that doesn't seem to go anywhere. What I was trying to to was show the location which appears to me to make it impossible to drill and tap without pulling the engine. Is that typically what you have to do to accomplish this repair? Thanks again.

Bob

You may have to remove the intake manifold...that is were the fitting is right? You don't want the drill shavings down in the cylinders!
Feb 6, 2008 at 1:07 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle