1992 Chevy S-10 gear pop

1992 CHEVROLET S-10
125,000 MILES • 6 CYL • 2WD • MANUAL
Avatar
MENACEINDUSTRIES
  • MEMBER
  • 1 POST
On my Chevy S-10, I have recently replaced the clutch and now I am having the issue with first and second gear popping out when I go to take off. Is it because of a damaged gear or something that might be simpler than that?
Dec 22, 2007 at 3:34 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
MHPAUTOS
  • CAR REPAIR CONTRIBUTOR
  • 31,937 POSTS
Hi there,

If this was not a problem before the clutch was replaced. Check that the gear box is tight on the engine, the rear gearbox mount is aligned as it was before, (you should be able to see where it was siting) this sounds like a miss alignment problem.

Mark (mhpautos)
Dec 22, 2007 at 3:41 AM
Advertisement