1991 Chevy S-10 clutch slave cylinders

1991 CHEVROLET S-10
156,000 MILES • 6 CYL • 2WD • MANUAL
Avatar
CLAYTONAYRES
  • MEMBER
  • 1 POST
I was Bleeding the clutch and the push rod fell out, how do i get it back into the slave cylinder
Oct 26, 2008 at 5:14 PM
Advertisement
Avatar
MHPAUTOS
  • ✓ASE Certified Mechanic
  • 31,937 POSTS
  • ASE Certified Mechanic
HI there,

Open the bleeder and just push the piston back and insert the push rod, you may have to take the slave off the gear box to get better access.

Mark (mhpautos)
Oct 26, 2008 at 5:53 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.