1986 Chevy S-10 hydrauliic clutch bleeding

1986 CHEVROLET S-10
107,500 MILES • 6 CYL • 2WD • MANUAL
Avatar
LONEWOLF2634
  • MEMBER
  • 1 POST
I was just wondering if there is any special procedure to bleeding a clutch. Ihave tried a couple times and the clutch does not seem to be getting any better if anything it is higherin the relaease.
Oct 13, 2010 at 10:54 PM
Advertisement
Avatar
BMRFIXIT
  • ✓Experienced Mechanic
  • 19,053 POSTS
BLEEDING HYDRAULIC CLUTCH SYSTEM
Fill reservoir with clean DOT 3 brake fluid. Raise vehicle. Disconnect slave cylinder from bellhousing, leaving line attached. Hold slave cylinder at angle of 45° with bleeder screw at highest point.
Have an assistant depress clutch pedal while you open bleeder. Close bleeder and release pedal. Repeat sequence until all air is removed from system. Make sure master cylinder reservoir stays full during bleeding process.
Oct 13, 2010 at 11:10 PM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle