1997 Chevy Monte Carlo Brake noise after replacing pads and

1997 CHEVROLET MONTE CARLO
107,000 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
SMOKENHEAT71
  • MEMBER
  • 1 POST
Recently I replaced rear pads and rotors and one caliper, it was fine at first, but after a few days they started making a clunking noise when the car was almost stopped. Stops fine, but the noise has me wondering what I did wrong...lol
Mar 17, 2009 at 9:51 AM
Advertisement
Avatar
BLACKOP555
  • ✓Experienced Mechanic
  • 10,386 POSTS
make sure the bolts are properly torqued down again, they could have loosened up. make sure they are holding pressure and not sticking either.
Mar 17, 2009 at 2:08 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.