vibration felt in steering wheel

2006 CHEVROLET IMPALA
70,000 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
SAMPALA
  • MEMBER
  • 1 POST
while taking a gradual left curve i feel a vibration or ticking through the steering wheel but not on a right curve,also a slight grinding or rubbing noise while going slow(e.g. through a drive through or turning into a drive way) started about 2 weeks ago but getting more noticeable now.
Oct 9, 2010 at 7:19 AM
Advertisement
Avatar
MMPRINCE4000
  • ASE Certified Mechanic
  • 8,548 POSTS
  • ASE Certified Mechanic
Inspect the CV axle boots for rips/tears. If OK, then try this:

Raise car, put on stands. Grasp tire and push/pull both horizontally and vertically. Any movement would indicate wheel bearing, ball joint, tie rods, control arm/bushings
Oct 9, 2010 at 8:39 AM
Avatar
CARADIODOC
  • ASE Certified Mechanic
  • 34,321 POSTS
  • ASE Certified Mechanic
Hi sampala. Welcome

This sounds like you have a bearing hub going out I would lift the car in the front to roll each wheel to find the bearing that is out here is how you can replace the hub in the diagram below. Check out the diagrams (Below). Please let us know what happens. caradiodoc
Oct 9, 2010 at 8:40 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.