2005 Chevy Impala trac control and noise

have is checked for trouble codes and get back to me

i cannot get a code ,a mechanic says that a wheel sensor may be at foult

why cant you get a code.

don,t have a code reader,the only garage in my area dosen,t have one yet

check out the 2 car pros store, they have them in there

no 2pro car stores here ,i am in nova scotia ,canada, the only gm garage will charge me $65 dollars to perform a scan check,that,s too much for me ,on pension.when i turn off the trac. control when i pull away from a stopped position the problem is gone ,only there when trac. control is on.was told it is a bearing sensor,loose wire or a wheel bearing is going bad

most likely it is a bad wheel bearing or a broken wire. I just like to verify the code and what the problem is before I throw parts at it. That could get more expensive than just having someone see what the code is and fixing it correctly

thank you,i,ll check out both front wheel bearings and the sensor wires,gord

I'm no help but I had the same problem with my 2003 Impala.
When I turned left with my trailer on the car the trac light came on.
I pulled over, stopped the engine and restarted. This put the light out 'till next time.
The problem is gone for the past two months.
I'm also in NS. Outside of Truro.

Austin