WHAT IS THE PROPER PROCEDURE TO BLEED AIR OUT OF THE COOLING SYSTEM USING THE BLEEDER SCREW IN THE THERMOSTAT HOUSINGON A 3800 V-6
Jan 16, 2008 at 9:18 PM
2000 Chevy Impala AIR LOCK
2000 CHEVROLET IMPALA
K_WENDELLH
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
[quote:ee4eba3b80="k_wendellh"]Heater problem
2000 Chevy Impala 6 cyl Front Wheel Drive Automatic 105000 miles
----------------------------------------------------------------
WHAT IS THE PROPER PROCEDURE TO BLEED AIR OUT OF THE COOLING SYSTEM USING THE BLEEDER SCREW IN THE THERMOSTAT HOUSINGON A 3800 V-6[/quote:ee4eba3b80]
open bleeder
add coolant until full
close bleeder start engine add coolant as needed
close and let it run until thermostat open and you have heat inside
car off wait to cool off open and recheck
2000 Chevy Impala 6 cyl Front Wheel Drive Automatic 105000 miles
----------------------------------------------------------------
WHAT IS THE PROPER PROCEDURE TO BLEED AIR OUT OF THE COOLING SYSTEM USING THE BLEEDER SCREW IN THE THERMOSTAT HOUSINGON A 3800 V-6[/quote:ee4eba3b80]
open bleeder
add coolant until full
close bleeder start engine add coolant as needed
close and let it run until thermostat open and you have heat inside
car off wait to cool off open and recheck
Jan 16, 2008 at 9:34 PM
Advertisement