1999 Chevy Express ECM-1 20 Amp Fuse blows

1999 CHEVROLET EXPRESS
104,680 MILES • V8 • 2WD • AUTOMATIC
Avatar
RYAN1398
  • MEMBER
  • 1 POST
I was advised to replace ecm module and I did . it worked for about a month. I also have a misfire code #1 cyl since the new ecm module was replaced and the ECM-1 fuse blows.the ecm 1 fuse was blowing before I replaced the old ecm module. the mechanic believed that the ecm was bad. it appeared that he was right but I now have the same problem
Jan 12, 2010 at 10:09 PM
Advertisement
Avatar
DAVE H
  • ✓ASE Certified Mechanic
  • 13,384 POSTS
  • ASE Certified Mechanic
Hello .. thanks for the donation .. much appreciated Unplug the ECM wiring connector from the ECM .. replace the fuse .. if the fuse still blows, you have a bad wire somewhere .. if the fuse does not blow, the ECM is bad and needs replacing again ! Hope this helps


https://images.2carpros.com/forum/automotive_pictures/266999_AAA2_957.png

Jan 13, 2010 at 6:40 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.